Manufacturer Part No:DAC104S085CIMM/NOPB

Product Overview

The DAC104S085CIMM/NOPB is a full-featured general purpose quad 10-bit voltage-output Digital-to-analog Converter (DAC) operates from a single 2.7 to 5.5V supply and consumes 1.1mW at 3V and 2.5mW at 5V. The on-chip output amplifier allows rail-to-rail output swing and the three wire serial interface operates at clock rates up to 40MHz over the entire supply voltage range. Competitive devices are limited to 25MHz clock rates at supply voltages in the 2.7 to 3.6V range. The serial interface is compatible with standard SPI, QSPI, MICROWIRE and DSP interfaces. The reference for the DAC104S085 serves all four channels and can vary in voltage between 1V and VA, providing the widest possible output dynamic range. The DAC has a 16-bit input shift register that controls the outputs to be updated, the mode of operation, the power-down condition and the binary input data. All four outputs can be updated simultaneously or individually depending on the setting of the two modes of operation bits.
  • Ensured monotonicity
  • Low power operation
  • Rail-to-rail voltage output
  • Power-ON reset to 0V
  • Simultaneous output updating
  • Wide power supply range
  • Setting time – 6µs maximum
  • Zero code error – 15mV maximum
  • Full-scale error -0.75%FS maximum
  • Green product and no Sb/Br


Medical, Sensing & Instrumentation, Automation & Process Control

Product Information

2.7V to 5.5V
3 Wire, Serial
Cut Tape
MSL 1 – Unlimited


There are no reviews yet.

Only logged in customers who have purchased this product may leave a review.